Colorado Aviation Accidents & Incidents
Learn from Colorado's accident history to fly safer in the Rockies
2310 Total Accidents
425 Fatal
816 Fatalities
1982-2026
← Back to all accidents
Serious Injury
FORT COLLINS, Colorado
NTSB Narrative
HISTORY OF FLIGHT
On November 15, 1993, approximately 1215 mountain standard time, a Cessna 172N, N4829E, was destroyed during a forced landing in a field near Fort Collins, Colorado, after the engine lost power. The pilot was seriously injured. Visual meteorological conditions prevailed, and no flight plan was filed for the instructional flight.
The following is based on interviews with the pilot and the Pilot/Operator Report. This was to be a student solo flight to the Fort Collins-Loveland Airport for touch-and-go landing practice. After takeoff, he made a right 30 degree crosswind noise abatement turn at an altitude between 800 and 1,000 feet above ground level (AGL), engine power decreased to idle. The pilot declared an emergency, attempted to troubleshoot the problem, then committed himself to a forced landing on a snow and ice-covered field. Braking action was nil and the airplane went down a hill and collided with an irrigation ditch.
TESTS AND RESEARCH
During an examination of the airplane, the following was revealed: A cotter pin (p/n 82-14, ref. no. 51) that fits into the lock nut (p/n 81-311, ref. no. 49) on the throttle lever (p/n 12-B57, ref. no. 2) was missing. The serrated surfaces of the throttle lever were not meshed and were riding on top of each other. The throttle valve (p/n 14-190, ref. no. 4) was closed because the throttle opening spring (p/n 24-A10, ref. no. 24), designed to fully open (page number. 11-42) was broken.
The following entry was made in the airplane's Maintenance Discrepancy Log: "11/12/93 DISCREPANCY: Throttle shaft loose. REPAIRED OR DEFERRED: Removed carburetor and removed throttle
shaft from carburetor to inspect for wear. New throttle shaft and bushings on order. Reinstalled throttle shaft with proper torque and safety. Reinstalled carburetor on aircraft. Removal and installation done in accordance with Cessna Service Manual 11-42." Similar entries were made in the airframe and engine logbooks. At the time the work was performed, the airplane;'s total time in service and tachometer reading was 4148.5. At the accident site, the tachometer read 4148.5.
The airplane mechanic was asked if he recalled installing the cotter pin in the throttle lever lock nut. He answered, "I'm almost sure I did." POWER LOSS DUE TO THROTTLE LINKAGE DISCONNECT. FACTORS WERE MISSING COTTER KEY, IMPROPER MAINTENANCE, AND THE LACK OF SUITABLE TERRAIN FOR THE FORCED LANDING.
On November 15, 1993, approximately 1215 mountain standard time, a Cessna 172N, N4829E, was destroyed during a forced landing in a field near Fort Collins, Colorado, after the engine lost power. The pilot was seriously injured. Visual meteorological conditions prevailed, and no flight plan was filed for the instructional flight.
The following is based on interviews with the pilot and the Pilot/Operator Report. This was to be a student solo flight to the Fort Collins-Loveland Airport for touch-and-go landing practice. After takeoff, he made a right 30 degree crosswind noise abatement turn at an altitude between 800 and 1,000 feet above ground level (AGL), engine power decreased to idle. The pilot declared an emergency, attempted to troubleshoot the problem, then committed himself to a forced landing on a snow and ice-covered field. Braking action was nil and the airplane went down a hill and collided with an irrigation ditch.
TESTS AND RESEARCH
During an examination of the airplane, the following was revealed: A cotter pin (p/n 82-14, ref. no. 51) that fits into the lock nut (p/n 81-311, ref. no. 49) on the throttle lever (p/n 12-B57, ref. no. 2) was missing. The serrated surfaces of the throttle lever were not meshed and were riding on top of each other. The throttle valve (p/n 14-190, ref. no. 4) was closed because the throttle opening spring (p/n 24-A10, ref. no. 24), designed to fully open (page number. 11-42) was broken.
The following entry was made in the airplane's Maintenance Discrepancy Log: "11/12/93 DISCREPANCY: Throttle shaft loose. REPAIRED OR DEFERRED: Removed carburetor and removed throttle
shaft from carburetor to inspect for wear. New throttle shaft and bushings on order. Reinstalled throttle shaft with proper torque and safety. Reinstalled carburetor on aircraft. Removal and installation done in accordance with Cessna Service Manual 11-42." Similar entries were made in the airframe and engine logbooks. At the time the work was performed, the airplane;'s total time in service and tachometer reading was 4148.5. At the accident site, the tachometer read 4148.5.
The airplane mechanic was asked if he recalled installing the cotter pin in the throttle lever lock nut. He answered, "I'm almost sure I did." POWER LOSS DUE TO THROTTLE LINKAGE DISCONNECT. FACTORS WERE MISSING COTTER KEY, IMPROPER MAINTENANCE, AND THE LACK OF SUITABLE TERRAIN FOR THE FORCED LANDING.
Case Study & Lessons Learned
Generating educational case study...
Details
| NTSB Report | FTW94FA034 |
| Aircraft | CESSNA 172N |
| Registration | N4829E |
| Damage | DEST |
| FAR Part | 091 |
| Location | 40.5497, -105.0595 |
