Colorado Aviation Accidents & Incidents
Learn from Colorado's accident history to fly safer in the Rockies
2310 Total Accidents
425 Fatal
816 Fatalities
1982-2026
← Back to all accidents
Minor/None
JOHNSTOWN, Colorado
NTSB Narrative
On July 1, 1996, between 1545 and 1630 mountain daylight time, a Cessna 172L, N19682, struck two sets of power lines while maneuvering near Johnstown, Colorado. The private pilot and his three passengers were not injured and the aircraft sustained substantial damage. The flight was operating under Title 14 CFR Part 91 when the accident occurred and no flight plan was filed. Visual meteorological conditions prevailed for this local area flight which departed Centennial Airport, Englewood, Colorado, at 1500.
The rural electric company, whose lines were struck, reported the accident and this was collaborated by a local resident who witnessed the second wire strike and provided the power company with a part which was sheared from the aircraft. The accident was not reported by the pilot and the aircraft was located the following day parked in a shelter at Centennial Airport, Englewood, Colorado, by matching a part, which came off the aircraft during the second wire strike. Approximately 1/3 of the vertical stabilizer was recovered from the area where the second wire strike occurred.
According to the electric company, the first power lines which were struck had a span between poles of 265 feet and the wire height at the point of contact was approximately 23 feet above ground level (agl). The second strike span was 305 feet with a wire height at the point of impact of approximately 25 feet agl. The type of wire used in both lines was 8A copper weld. The two wire strikes were approximately one mile apart. The lines were not marked and according to Federal Air Regulations, they did not meet the requirements for marking.
The line locations are depicted on the attached map. This depiction provided information that the lines were located approximately 3 miles southeast of Fort Collins/Loveland Municipal Airport and the sequence provides documentation that the aircraft was flying in a northwest direction when the wire strikes occurred.
Damage to the aircraft consisted of abrasion marks on the propeller, dents in the propeller spinner, abrasion marks on the top cowl, a broken wind screen, dents in the right door, abrasion marks and dents on the right strut, a broken right rear window, dents and abrasion marks on the top fuselage aft of the cabin, dents and abrasion marks in the right horizontal stabilizer, a crease with dents and upward deformation of the right elevator, abrasion marks and dents in the leading edge of the vertical stabilizer, the top 1/3 of the vertical stabilizer and rudder sheared off, damage to the center hinge of the retained portion of the rudder, and antennas sheared off on the top side of the aircraft. (Photographs attached.)
According to the pilot's statement, provided on NTSB Form 6120.1/2, he was flying north towards Fort Collins, Colorado, at about 150 feet above the ground. He said he glanced down to adjust the mixture and apparently hit a small down draft, or pushed the nose over. He said he descended about 100 f
The rural electric company, whose lines were struck, reported the accident and this was collaborated by a local resident who witnessed the second wire strike and provided the power company with a part which was sheared from the aircraft. The accident was not reported by the pilot and the aircraft was located the following day parked in a shelter at Centennial Airport, Englewood, Colorado, by matching a part, which came off the aircraft during the second wire strike. Approximately 1/3 of the vertical stabilizer was recovered from the area where the second wire strike occurred.
According to the electric company, the first power lines which were struck had a span between poles of 265 feet and the wire height at the point of contact was approximately 23 feet above ground level (agl). The second strike span was 305 feet with a wire height at the point of impact of approximately 25 feet agl. The type of wire used in both lines was 8A copper weld. The two wire strikes were approximately one mile apart. The lines were not marked and according to Federal Air Regulations, they did not meet the requirements for marking.
The line locations are depicted on the attached map. This depiction provided information that the lines were located approximately 3 miles southeast of Fort Collins/Loveland Municipal Airport and the sequence provides documentation that the aircraft was flying in a northwest direction when the wire strikes occurred.
Damage to the aircraft consisted of abrasion marks on the propeller, dents in the propeller spinner, abrasion marks on the top cowl, a broken wind screen, dents in the right door, abrasion marks and dents on the right strut, a broken right rear window, dents and abrasion marks on the top fuselage aft of the cabin, dents and abrasion marks in the right horizontal stabilizer, a crease with dents and upward deformation of the right elevator, abrasion marks and dents in the leading edge of the vertical stabilizer, the top 1/3 of the vertical stabilizer and rudder sheared off, damage to the center hinge of the retained portion of the rudder, and antennas sheared off on the top side of the aircraft. (Photographs attached.)
According to the pilot's statement, provided on NTSB Form 6120.1/2, he was flying north towards Fort Collins, Colorado, at about 150 feet above the ground. He said he glanced down to adjust the mixture and apparently hit a small down draft, or pushed the nose over. He said he descended about 100 f
Case Study & Lessons Learned
Generating educational case study...
Details
| NTSB Report | FTW96LA290 |
| Aircraft | Cessna 172L |
| Registration | N19682 |
| Damage | SUBS |
| FAR Part | 091 |
| Location | 40.3303, -104.9107 |
